Courtesy Lamp: Service and Repair
INTERIOR LIGHT REMOVAL/INSTALLATION1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. A-pillar trim
2. Front scuff plate inner
3. Rear scuff plate
4. B-pillar lower trim
5. Front seat belt upper anchor installation bolt
6. B-pillar upper trim
7. Rear package tray lid
8. Sub-trunk
9. Third-row seat
10. Rear header trim
11. Trunk end trim
12. Third-row seat belt lower anchor installation bolt
13. Cargo compartment light
14. Trunk side trim
15. Second-row seat belt upper anchor installation bolt
16. C-pillar trim
17. Map light
18. Assist handle
19. Sunvisor
20. Headliner
4. Detach the tab and remove the bulb housing.
NOTE: The valve housing and the wiring harness have been integrated and attached to the headliner. The wiring harness passes under the urethane and shock absorption pad, so if the valve housing is to be replaced, cut the urethane and then cut and remove the shock absorption pad.
5. Pull in the direction of the arrows and detach the tabs.
6. Remove the interior light.
7. Install in the reverse order of removal.
NOTE: Install a new shock absorption pad by applying adhesive to the areas where the previous shock absorption pad was removed after installing the wiring harness. Also, after installing the wiring harness and shock absorption pad, reinforce the areas where the urethane was cut with vinyl tape.