Clutch Cover Inspection

CLUTCH COVER INSPECTION





1. Measure the wear of the diaphragm spring fingers.
^ If it exceeds the maximum specification, replace the clutch cover.

Clutch cover diaphragm spring fingers maximum depth
0.6 mm (0.024 inch)





2. Measure the flatness of the pressure plate with a straight edge and a feeler gauge.
^ If it exceeds the maximum specification, replace the clutch cover.

Maximum clearance of flatness of the pressure plate
0.5 mm (0.020 inch)

3. When checking the diaphragm spring fingers, mount a dial indicator on the cylinder block.





4. Rotate the flywheel and check for misaligned diaphragm spring fingers.
^ If it exceeds the maximum specification, replace the clutch cover.

Clutch cover diaphragm spring fingers maximum misalignment
1.0 mm (0.039 inch)