Power Window Motor: Service and Repair

POWER WINDOW MOTOR REMOVAL/INSTALLATION

1. Half open the door glass.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the following parts:
Front door
- Inner garnish Front door trim

Sliding door
- Side door garnish.
- Rear side trim.
- Sliding door trim.




5. Remove the bolts.
6. Remove the power window motor from the power window regulator drum.
7. Disconnect the power window motor connector.
8. Install in the reverse order of removal.

NOTE: When installing the power window motor to the power window regulator drum, the drum housing tabs may detach from the door module. If this happens, insert a hand through the service hole to engage the drum housing tabs, and install the power window motor to the drum while supporting the drum housing.