Oil Pan: Service and Repair

OIL PAN REMOVAL/INSTALLATION
L3
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Drain the engine oil.
4. Remove the engine front cover.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Refill the engine oil with the specified type and amount.
8. Start the engine and inspect for oil leakage.
- If the oil leaks, specify the faulty part and repair or replace it.





9. Inspect the oil level.

Oil Pan Installation Note (L3)





1. Use a square ruler to align the junction of the oil pan and the cylinder block on the engine front cover side.





2. Apply silicone sealant to the oil pan along the inside of the bolt holes.





3. Tighten the bolts in the order as shown in the figure.