Oil Pump: Service and Repair
OIL PUMP REMOVAL/INSTALLATION1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Remove the oil pan.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Start the engine and inspect for oil leakage.
- If the oil leaks, specified the faulty part and repair or replace it.
7. Inspect the oil level.
8. Inspect the oil pressure.
9. Install the under cover.
Oil Pump Sprocket Removal/installation Note
1. Install the SST to the oil pump sprocket to stop the oil pump from rotating.
Oil Pump Installation Note
1. Tighten the oil pump bolts in two steps in the order indicated in the figure.
Tightening torque:
1) 8 - 10 Nm (81.6 - 101.9 kgf-cm, 70.9 - 88.4 inch lbs.)
2) 20 - 25 Nm (2.1 - 2.5 kgf-cm, 15.2 - 18.4 ft. lbs.)