Variable Tumble Solenoid Valve Inspection

VARIABLE TUMBLE SOLENOID VALVE INSPECTION

1. Remove the variable tumble control solenoid valve. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION.)







2. Inspect airflow between the ports under the following conditions.
- If not as specified, replace the variable tumble control solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".

Circuit Open/Short Inspection




1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION,)
2. Inspect the following wiring harness for open or short circuit (continuity check).




California emission regulation applicable ATX model




Except for California emission regulation applicable ATX model

Open circuit

- If there is no continuity, there is an open circuit. Repair or replace the harness.
- Variable tumble control solenoid valve terminal B and PCM terminal 74*1,4T*2
- Variable tumble control solenoid valve terminal A and main relay terminal C

Short circuit

- If there is continuity, there is a short circuit. Repair or replace the harness.
- Variable tumble control solenoid valve terminal B and body GND
- Variable tumble control solenoid valve terminal A and power supply

*1 : California emission regulation applicable ATX model
*2 : Except for California emission regulation applicable ATX model