Programming and Relearning

POWER WINDOW INITIALIZATION PROCEDURE

NOTE:
- Initial setting must be performed for the switch of each window front and rear.
- If the following operations have been performed, initial setting is reset, and auto up/down and two-step down operation are disabled. Therefore, performing initial setting is necessary.
- Negative battery cable disconnected or power window system power supply fuse removed (perform initial setting for the switches of all seats.)
- Power window switch connector disconnected (Perform initial setting for the switch connected with the connector.)
- Prolonged open/close operation of the power window main or sub switches causes the circuit breaker to activate and automatic operation is disabled.

1. Turn the ignition switch to the ON position.
2. Press the switch of each window and fully open the door glass.
3. Pull the switch of each window to the manual-up position to fully close the door glass, and keep holding the switch up at the position for approx. 2 s.