Component Tests and General Diagnostics

BCM SELF-TEST




1. Connect the WDS or equivalent to the DLC-2.
2. Set up the WDS or equivalent (including the vehicle recognition).
3. Verify the following vehicle conditions:
- Ignition switch is at ON position.
- All the switches are turned off (except the ignition switch).
- All the doors, hood, trunk lid, and liftgate are closed.
- All the doors, and liftgate are unlocked.
- Parking brake lever is pulled.
- Hazard warning switch is turned to off.
- Turn switch is turned to off.
- Rear wiper switch is turned to off.
- Door lock switch is not pressed.

4. Perform procedures according to directions on the WDS or equivalent screen.
5. Verify if any DTCs are displayed.
- If any DTCs are displayed, perform the troubleshooting according to the corresponding DTC inspection.

6. Disconnect the WDS or equivalent.