Component Tests and General Diagnostics

Intake Manifold Vacuum Inspection

1. Verify air intake hoses are installed properly.
2. Start the engine and run it at idle.
3. Disconnect the vacuum hose between the intake manifold and purge solenoid valve from the intake manifold side.
4. Connect a vacuum gauge to the intake manifold and measure the intake manifold vacuum.
- If not as specified, inspect the following:

Specification: More than 60 kPa {450 mmHg. 18 in Hg}

NOTE:
- Air suction can be located by the engine speed change when lubricant is sprayed on the area where suction occurs.