Disassembly Procedure

Disassembly Procedure





1. Using a flathead screwdriver, remove the snap ring from the C3 clutch drum.





2. Remove the retaining plate, drive and driven plates from the C3 clutch drum.

Note: Inspect the number of drive and driven plates.





3. Place the SST on the clutch balancer and compress the return spring with a press.

Caution: Be careful not to expand the snap ring too much.

4. Remove the snap ring using snap ring pliers.

Caution: Do not damage the seal on the clutch balancer.





5. Remove the clutch balancer, return spring and the retainer from the C3 clutch drum.





6. While pushing the C3 clutch piston by hand, apply compressed air into the oil passage as shown in the figure and remove the C3 clutch piston from the C3 clutch drum.

Air pressure:
392 kPa (4.0 kgf/cm2, 57 psi)

Note: When applying compressed air, shut the 3 oil passages of the C3 clutch drum as shown in the figure.





7. Remove the O-rings from the C3 clutch drum.