Seat Back Crossmember Assembly Removal/Installation

SEAT BACK CROSSMEMBER ASSEMBLY REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the console.
3. Remove the quarter trim.
4. Remove the scuff plate.
5. Remove the tire house trim.
6. Remove the aeroboard.
7. Remove the seat back bar garnish.
8. Remove the open hook lever.
9. Remove the back trim.
10. Remove the open hook.
11. Remove the rear speaker.
12. Remove the seat belt set plate.
13. Remove the clips, then remove the speaker wiring harness.






14. Remove in the order indicated in the table.
15. Install in the reverse order of removal.