Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2006 >> MX-5 Miata L4-2.0L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Testing and Inspection >> Component Tests and General Diagnostics >> Using the WDS or Equivalent

Using the WDS or Equivalent

Using the WDS or Equivalent

NOTE:
- PIDs for the following parts are not available on this model. Go to the appropriate part inspection.
- CMP sensor
- Main relay




1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON position.
3. Measure the PID value.
- If PID value is not within the specification, follow the instructions in "Inspection item (s)" column.

NOTE:
- The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM. Therefore, an output device malfunction is not directly indicated as a malfunction of the monitored value for the output device. If a monitored value of an output device is out of specification, inspect the monitored value of the input device related to the output control.
- For input/output signals except those of the monitoring items, use a voltmeter to measure the PCM terminal voltage.
- The simulation items that are used in the ENGINE CONTROL SYSTEM OPERATION INSPECTION are as shown.
- ACCS, ALTF, EVAPCP, FAN1, FAN2, FANS, FP, FUELPW1, GENVDSD, HTR11, HTR12, IMTV, INJ_1, INJ 2, INJ 3, INJ 4, SEGRR test, VT DUTY1 Wt
pro multis · About Operation CHARM