Rear
REAR ABS WHEEL-SPEED SENSOR INSPECTIONInstallation Visual Inspection
1. Inspect the following items:
^ If there is any malfunction, replace the applicable part.
1. Excessive looseness or play of the ABS wheel-speed sensor
2. Deformation of the ABS wheel-speed sensor
3. Deformation or damage of the ABS sensor rotor
Clearance Inspection
1. Verify the clearance between the ABS sensor rotor and the ABS wheel-speed sensor.
^ If there is any malfunction, check for improper installation, and replace if necessary.
Clearance 0.8 - 1.6 mm (0.032 - 0.062 inch)
Sensor Output Value Inspection
1. Turn the ignition switch off.
2. Connect the WDS or equivalent to the DLC-2.
3. Select the following PIDs using the WDS or equivalent:
^ LR_WSPD
(LR wheel-speed sensor)
^ RR_WSPD
(RR wheel-speed sensor)
4. Start the engine and drive the vehicle.
5. Verify that the display of the WDS or equivalent shows the same value as the speedometer.
^ If there is any malfunction, replace the rear ABS wheel-speed sensor.