Input/Turbine Speed Sensor Removal/Installation [FS5A-EL]

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL]





1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner component.
4. Disconnect the input/turbine speed sensor connector.
5. Remove the input/turbine speed sensor.
6. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
7. Install the input/turbine speed sensor.
Tightening torque 8 - 11 Nm (82 - 112 kgf-cm, 71 - 97 inch lbs.)
8. Connect the input/turbine speed sensor connector.
9. Install the air cleaner component.
10. Install the battery and battery tray.
11. Connect the negative battery cable.