Removal and Replacement

CENTER PANEL MODULE REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the lower panel.
3. remove the ashtray panel.
4. Remove the ventilator grille.





5. Remove in the order indicated in the table
6. Install in the reverse order of removal.

CAUTION:
- When installing the center panel module, make sure that the wiring harness and antenna feeder are not caught between the unit and the dashboard. If the wiring harness or the antenna feeder is caught between the unit and the dashboard, it may cause malfunctions.


Center Panel Module Removal Note





1. Pull the center panel module outward, detach clip A from the dashboard, and then remove the center panel module.

Connector Removal Note

1. Put your hand through the opening where the ventilator grille was removed and disconnect the connectors.

CAUTION:
- When putting your hand through the opening, be careful not to contact the panel edge or sharp parts to avoid injury.