Steering Lock Unit ID Code Registration

STEERING LOCK UNIT ID CODE REGISTRATION [WITH ADVANCED KEYLESS SYSTEM]

CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed.
- M-MDS
- Personal computer
- Device that can send/receive radio waves

NOTE:
- The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit.
- For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.

1. Bring the programmed card key into the vehicle.
2. Fully lower the driver-side door glass.




3. Connect the M-MDS to the DLC-2.
4. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
5. Select "BODY/SECURITY/PATS (immobilizer)" from the M-MDS screen menu.
6. Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE.) Programming and Relearning
7. The security access begins and the M-MDS displays "OUT-CODE".

NOTE: When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times will change the "OUT-CODE".

8. Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed on the M-MDS screen.
9. Select "STEERING LOCK UNIT PROGRAMMING" and perform procedures according to the directions on the M-MDS screen.