B-Pillar Upper Trim Removal and Installation [Detachable Hardtop

B-PILLAR UPPER TRIM REMOVAL [DETACHABLE HARDTOP]

1. Remove the detachable hardtop.
2. Remove the B-pillar garnish.
3. Remove the side lock.






4. Disengage the B-pillar upper trim clips A using a fastener remover.
5. While cutting the double-sided adhesive tape using a screwdriver or a razor, separate the B-pillar upper trim from the body.

WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

6. Remove the B-pillar upper trim.

B-PILLAR UPPER TRIM INSTALLATION [DETACHABLE HARDTOP]

NOTE: Double-sided adhesive tape has already been attached to the new rear door garnish.

WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

1. When installing a new B-pillar upper trim, follow the procedure below:
1. Remove the adhesive remaining on the body using razor.
2. Remove any grease or dirt from the adhesion surface of the body.






2. When reusing the B-pillar upper trim, follow the procedure below:
1. Remove the adhesive remaining on the B-pillar upper trim and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the B-pillar upper trim and the body.
3. Apply primer to the bonding area of the B-pillar upper trim.
4. Attach double-sided adhesive tape to the B-pillar upper trim as shown.

NOTE: Use 3M GT7108 double-sided adhesive tape or equivalent.

3. Peel off the backing of the double-sided adhesive tape, then install the B-pillar upper trim to the detachable hardtop.