Power Retractable Hardtop Link Bracket Removal/Installation

POWER RETRACTABLE HARDTOP LINK BRACKET REMOVAL/INSTALLATION

1. Remove the following parts:
1. Console
2. Quarter trim
3. Scuff plate
4. Tire house trim
5. Aeroboard
6. Front seat back bar garnish
7. Back trim
8. Seat belt upper anchor installation bolt






2. Remove the bolts A, B and C.
3. Remove the junction.
4. Loosen the installation bolts and nuts of the seat back crossmember component, and tilt the seat back crossmember component towards the vehicle front.






5. Rotate the power retractable hardtop link bracket in the direction shown by the arrow at the pivot fulcrum of pin A and set the hook out of the way.
6. Remove the power retractable hardtop link bracket.
7. Install in the reverse order of removal.

Bolt B, C Install Note






1. Temporarily tighten all the bolts, then tighten the bolts in the order indicated in the figure.

Tightening torque
19-25 N.m {1.9-2.6 kgf.m, 14-18 ft.lbf}