Variable Induction System: Testing and Inspection
Variable Intake air Control Operation Inspection1. Start the engine.
2. Inspect the rod operation. (See VARIABLE INTAKE AIR SHUTTER VALVE ACTUATOR INSPECTION [LF].)
- If the rod operation is not as specified, inspect as follows:
1. Stop the engine.
2. Connect the WDS or equivalent to the DLC-2.
3. Verify that DTC P0661 or P0662 is not displayed.
- If DTC P0661 or P0662 is shown, perform DTC inspection. (See DTC TABLE [LF].) Diagnostic Trouble Code Descriptions
4. Inspect the variable intake air solenoid valve.
- If the variable intake air solenoid valve is not normal, replace the variable intake air solenoid valve.
- If the variable intake air solenoid valve is normal, inspect the following:
- Vacuum hose and vacuum chamber for looseness or damage
- Shutter valve actuator
- Shutter valve stuck open or closed.