Convertible Top Position Sensor / Switch: Service and Repair
POWER RETRACTABLE HARDTOP LIMIT SWITCH REMOVAL/INSTALLATIONNOTE: The power retractable hardtop limit switch is installed on the RH side.
1. Fully open the deck panel.
2. Cover both sides of the rear window glass with thick cloth to protect the window.
3. Remove the battery cover.
4. Disconnect the negative battery cable.
5. Remove the following parts:
1. Console
2. Quarter trim
3. Scuff plate
4. Tire house trim
5. Aeroboard
6. Front seat back bar garnish
7. Back trim
8. Seat belt upper anchor installation bolt
9. Power retractable hardtop link bracket
10. Cab-side weatherstrip
6. Disconnect the roof motor limit switch connector.
7. Disconnect the power retractable hardtop drain hose.
8. Remove the power retractable hardtop.
9. Remove in the order indicated in the table.
10. Install in the reverse order of removal.
Cover Installation Note
1. Install the power retractable hardtop limit switch wiring harness to the cover hook and groove shown in the figure.