Part 2

36. After obtaining Incodes, select "YES" on IDS screen to continue.

37. Enter Incodes, then press tick.

38. Screen shows "Security Access Granted". Press tick.

39. Title of next screen shows "PARAMETER RESET" and the following information is displayed:

WARNING!
- You will need two keys to start the vehicle if you have replaced the PATS, IC, VIC, HEC or RKE module.

- Do you wish to continue?

- Select YES. Screen will now reset security ID.

40. Screen shows Blue status bar. When status bar reaches 100% "This operation has been successful" is displayed. Press tick.

41. Screen displays "Operation Successful". Press tick.

42. Screen displays "Which module have you replaced?" Select "IC", then press tick.

43. Screen displays "Module reset is now complete". Press tick.

44. Screen title displays "PATS FUNCTIONS". Select "IGNITION KEY CODE ERASE and PROGRAM". Press tick.

45. Next screen warns you to make sure you have TWO (2) keys. Select YES to continue. Ignition key codes will now be erased.

46. Screen shows Blue status bar. When status bar reaches 100% "This operation has been successful" is displayed. Press tick.

47. Screen displays "All known keys have been erased. You must now program a minimum of two keys". Press tick.

48. Next screen shows "Key Programming Procedure" DO NOT FOLLOW THESE PROCEDURES, go immediately to STEP 49.

49. Turn ignition OFF and disconnect IDS from vehicle DLC. DO NOT turn off IDS.

50. Turn 1st key to ON position (do not start engine) for 3 seconds. PATS light remains OFF. This is normal. Turn key OFF and remove.

51. Insert 2nd key and turn to ON position (do not start engine) for 3 seconds. PATS light remains OFF. This is normal. Start engine. Turn key OFF and remove.

52. Insert 1st key and turn to ON position. Confirm PATS light stays ON 3 seconds and then goes out. Start engine. Turn key OFF and remove. 2 keys are now programmed. Confirm PATS light blinks. If additional keys need programming, use the "Two Valid Key Program Method" in the next step. Otherwise, go to "COMPLETING PROCEDURE".

53. Insert 1st valid (programmed) key and then turn to ON position (do not start engine) until PATS light proves out.

54. Insert 2nd valid (programmed) key and then turn to ON position (do not start engine) until PATS light proves out.

55. Insert 1st spare (unprogrammed) key and turn ON (do not start engine) until PATS light proves out.

56. If there are additional spare keys, repeat previous step for each key.

57. If there are no additional spare keys, start engine with ALL keys to ensure programming is successful.

58. Confirm all spare keys can start engine.

COMPLETING PROCEDURE

59. Reconnect DLC to vehicle. Press tick.

60. Select "EXIT (From this menu)". Press tick.

61. Screen shows "Operation Action" screen.

62. Turn ignition switch ON, then press tick.

63. Screen shows "Select Option". Select "IGNITION KEY CODE ERASE and PROGRAM". Press tick.

64. Press tick again (to return to Vehicle Specification screen).

65. The configuration procedure is now completed.