Vehicle Speed Sensor (VSS) Inspection [SJ6A-EL]

VEHICLE SPEED SENSOR (VSS) INSPECTION [SJ6A-EL]

Caution: Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.

1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the tunnel member component.
4. Remove the middle pipe.





5. Remove the insulator.





6. Mark the manual shaft lever component as shown in the figure.
7. Separate the manual shaft lever component from selector lever.





8. Disconnect the VSS connector.

Caution:
^ Do not apply a shock in the VSS
^ Do not damage the terminals.





9. Measure the resistance between the VSS terminals.
^ If there is any malfunction, replace the VSS.

VSS resistance 560 - 680 ohm
10. Connect the VSS connector.





11. Align the mark of the manual shaft lever component as shown in the figure.
12. Install the manual shaft lever component installation nut.

Tightening torque 10.8 - 14.7 Nm (111 - 149 kegs-cm, 96.4 - 129.3 inch lbs.)
13. Install the insulator.

Tightening torque 8 - 11 Nm (82 - 112 kegs-cm, 72 - 97 inch lbs.)
14. Install the middle pipe.
15. Install the tunnel member component,
16. Connect the negative battery cable.
17. Install the battery cover.