Cylinder Block Inspection
CYLINDER BLOCK INSPECTION1. Measure the cylinder block for distortion in six directions as shown in the figure using a straight edge and feeler gauge.
^ If it exceeds the maximum specification, replace the cylinder block.
Maximum distortion, head gasket side
0.10 mm (0.004 in)
2. Measure the cylinder bore diameter using the cylinder gauge. The measurement position is in the X and Y directions at a point 42 mm below the top surface of the cylinder as shown in the figure.
^ If it exceeds the maximum specification, replace the cylinder block.
Maximum bore inner diameter
87.500-87.530 mm (3.4449-3.4460 in)