Component Tests and General Diagnostics

PJB SELF-TEST[CONTROL SYSTEM]




1. Connect the M-MDS to the DLC-2.
2. Set up the M-MDS (including the vehicle recognition).
3. Verify the following vehicle conditions:
- Ignition switch is at ON position.
- All the switches are turned off (except the ignition switch).
- All the doors, hood, and trunk lid or liftgate are closed.
- All the doors, and trunk lid or liftgate are unlocked.
- Parking brake lever is pulled.

4. Perform procedures according to directions on the M-MDS screen.
5. Verify if any DTCs are displayed.
- If any DTCs are displayed, perform the troubleshooting according to the corresponding DTC inspection.

6. Disconnect the M-MDS.