Torque Specifications
Cylinder Head
Measure the length of each cylinder head bolt.
- Replace any cylinder head bolts that exceed the maximum length.
Cylinder head bolt length
Standard 144.7 - 145.3 mm (5.700 - 5.720 in)
Maximum 146 mm (5.748 in)
Tightening procedure
(1) 3 - 11 Nm (30.6 - 112 kgf.cm, 26.6 - 97.3 in.lbf)
(2) 13 - 17 Nm (1.4 - 1.7 kgf.m, 9.6 - 12.5 ft.lbf)
(3) 43 - 47 Nm (4.4 - 4.7 kgf.m, 31.8 - 34.6 ft.lbf)
(4) 88° - 92°
(5) 88° - 92°
Camshaft Bearing
Install the camshaft caps and temporarily tighten the camshaft cap bolts evenly in two or three passes, and then tighten the camshaft cap bolts using the following two steps, in the order shown in the figure.
Tightening procedure
(1) 5.0 - 9.0 Nm (51.0 - 91.7 kgf.cm, 44.3 - 79.6 in. lbf)
(2) 14.0 - 17.0 Nm (1.5 - 1.7 kgf.m, 10.4 - 12.5 ft. lbf)
Crankshaft Main Bearing
Tightening procedure
(1) Apply engine oil to all bolts.
(2) 3 - 7 Nm (30.6 - 71.3 kgf-cm, 26.6 - 61.9 in lbf)
(3) 23 - 27 Nm (2.4 - 2.7 kgf-m, 17 - 19.9 ft lbf)
(4) 38 - 42 Nm (3.9 - 4.2 kgf-m, 28.1 - 30.9 ft lbf)
(5) Loosen all the bolts (until bolts are torque-free)
(6) 3 - 7 Nm (30.6 - 71.3 kgf-cm, 26.6 - 61.9 in lbf)
(7) 18 - 22 Nm (1.9 - 2.2 kgf-m, 13.3 - 16.2 ft lbf)
(8) 87.5° - 92.5°
Crankshaft Pulley
Tightening procedure
(1) 96 - 104 Nm (9.8 - 10.6 kgf.m, 70.9 - 76.7 ft.lbf)
(2) 87° - 93°
Oil Pump
Tighten the oil pump bolts in two steps in the order shown in the figure.
Tightening torque
Step 1 8 - 12 Nm (82 - 122 kgf.cm, 71 - 105 in. lbf)
Step 2 17 - 23 Nm (1.8 - 2.3 kgf.m, 12.6 - 16.9 ft. lbf)
Water Pump