Center Panel Module Removal/Installation

CENTER PANEL MODULE REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the ashtray panel.
3. Remove the lower panel.




4. Remove the screws and bolt.




5. Pull the center panel module outward, and then detach clip A from the dashboard.
6. Remove the ventilator grille (center).




7. Put your hand through the opening where the ventilator grille was removed and disconnect the connectors and the antenna feeder.

CAUTION: When putting your hand through the opening, be careful not to contact the panel edge or sharp parts to avoid injury.

8. Install in the reverse order of removal.

CAUTION: When installing the center panel module, make sure that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the wiring harness or the antenna feeder is caught between the unit and dashboard, It may cause malfunctions.