ABS Control Inspection

ABS Control Inspection
1. Perform "Preparation". Preparation





2. Connect the M-MDS to the DLC-2.
3. Set up an active command mode inspection according to the combination of commands below.

Brake Pressure Retention:

Brake Pressure Reduction:

Caution: To protect the DSC HU/CM, the solenoid valve and the pump motor used during active command mode stay on for only 10 s or less each time they are switched on.

Note: When working with two people, one should press on the brake pedal, and the other should attempt to rotate the wheel being inspected.

4. Send the command while depressing on the brake pedal and attempting to rotate the wheel being inspected.
5. While brake pressure is maintained and a DSC HU/CM operation click sound is heard, confirm that the wheel does not rotate. While brake pressure is being reduced and an DSC HU/CM operation click sound is heard, confirm that the wheel rotates.
^ Performing the inspection above determines the following:
- The DSC HU/CM brake lines are normal.
- The DSC HU/CM hydraulic system is not significantly abnormal (including DSC HU/CM).
- The DSC HU/CM internal electrical parts (solenoid, motor and other parts) are normal.
- The DSC unit and DSC HU/CM output system wiring harnesses (solenoid valve, relay system) are normal.
^ However, the following items cannot be verified.
- Malfunction with intermittent occurrence of the above items
- Malfunction of DSC HU/CM input system wiring harnesses and parts
- Extremely small leaks in the DSC HU/CM internal hydraulic system