DSC Control Inspection

DSC Control Inspection
1. Perform "Preparation". Preparation





2. Connect the M-MDS to the DLC-2.
3. Set up an active command mode inspection according to the combination of commands below.

Caution: To protect the DSC HU/CM, the solenoid valve and the pump motor used during active command mode stay on for only 10 s or less each time they are switched on.





4. Send the command while rotating the wheel being inspected by hand in a forward direction.
5. Confirm that the wheel does not rotate easily while a DSC HU/CM operation click sound is heard.
^ Performing the inspection above determines the following:
- The DSC HU/CM brake lines are normal.
- The DSC HU/CM hydraulic system is not significantly abnormal (including DSC HU/CM).
- The DSC HU/CM internal electrical parts (solenoid, motor and other parts) are normal.
- The DSC unit and DSC HU/CM output system wiring harnesses (solenoid valve, relay system) are normal.
^ However, the following items cannot be verified.
- Malfunction with intermittent occurrence of the above items
- Malfunction of DSC HU/CM input system wiring harnesses and parts
- Extremely small leaks in the DSC HU/CM internal hydraulic system