Removal and Replacement
INTAKE-AIR SYSTEM REMOVAL/INSTALLATIONWARNING:
- A hot engine and intake-air system can cause severe burns. Turn off the engine and wait until they are cool before removing the intake-air system.
- Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedure", while referring to the "BEFORE SERVICE PRECAUTIONS".
1. Drain the engine coolant.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Fresh-air Duct Removal Note
1. Remove the front bumper.
Fresh-air Duct Installation Note
1. Install the clips.
2. Tighten the bolt to the specified torque.
Tightening torque
7.8-10.8 N.m {79-111 kgf-cm, 69.0-95.6 in-lbf}
Air Cleaner Insulator Installation Note
1. Temporarily tighten nuts.
2. Temporarily tighten bolts.
3. Tighten the nuts to the specified torque.
4. Tighten the bolts to the specified torque.
Tightening torque
7.8-10.8 N.m {79-111 kgf-cm, 69.0-95.6 in-lbf}
Air Hose Installation Note
1. Align the alignment marks with the air hose notches.