[RC4A-El] Automatic Transmission/Transaxle

TRANSMISSION RANGE (TR) SWITCH INSPECTION [RC4A-EL)
Operating inspection
1. Verify that the starter operates only when the ignition switch is turned to the START position with the selector lever in the P or N position.
^ If there is any malfunction, adjust the TR switch.
2. Verify that the back-up lights illuminate when shifted to the R position with the ignition switch at the ON position.
^ If there is any malfunction, adjust the TR switch.





3. Verify that the positions of the selector lever and the indicator are aligned.
^ If there is any malfunction, adjust the TR switch.

Continuity Inspection

Caution: Water or foreign material, entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.

1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery, cable.
4. Remove the catalytic converter.





5. Remove the insulator.





6. Disconnect the TR switch connector.








7. Verify continuity as indicated in the table.
^ If there is any malfunction, adjust the TR switch.
8. Reinspect for continuity at TR switch.
^ If there is any malfunction, replace the TR switch.
9. Connect the TR switch connector.
10. Install the insulator.
Tightening torque 8-11 N-m (82-112 kgf-cm, 72-97 in-lbf)
11. Install the catalytic converter.
12. Connect the negative battery cable.
13. Install the battery cover.
14. Install the engine cover.