Control Valve Body Installation

CONTROL VALVE BODY INSTALLATION [RC4A-EL]
On-Vehicle Installation

Caution:
^ Do not move the manual valve in the direction of arrow to prevent the pin for manual valve rotation prevention from failing from the control valve body.





1. Align the manual valve and the manual plate and install the control valve body.
2. Install the installation bolts and connect the connectors as shown in the figure.








Tightening torque 6.9-8.8 N-m (71-89 kgf-cm, 62-77 in-lbf)
3. Install the oil pan and a new gasket to a new oil pan installation bolts.
Tightening torque 7.0-9.0 N-m (72-91 kgf-cm, 63-78 in.lbf)
4. Connect the negative battery cable.
5. Install the battery cover.
6. Install the engine cover.
7. Add ATF and, with the engine idling, inspect the ATF level and inspect for leakage.
8. Perform the mechanical system test. Mechanical System Test
9. Perform the road test. Road Test