Body Control Module: Testing and Inspection

PASSENGER JUNCTION BOX (PJB) CONFIGURATION




1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
1. Select "Module Programming".

- When using the PDS (Pocket PC)
1. Select "Programming".
2. Select "Module Programming".

3. Then, select items from the screen menu in the following order.
1. Select "Programmable Module Installation".
2. Select "GEM".

4. Perform the configuration according to the directions on the screen.
5. Then, select items from the screen menu in the following order.
1. Select "Programmable Parameters".
2. Select "Module Reset".
3. Select "GEM".

6. Retrieve DTCs by the M-MDS, then verity that there is no DTC present.
- If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE (PJB) [CONTROL SYSTEM].) Diagnostic Trouble Code Descriptions