Shift-Lock Inspection
SHIFT-LOCK INSPECTION1. Turn the ignition switch to the ON position (engine off).
2. Verify that the selector lever is in the P position.
3. Without the brake pedal depressed, verify that the selector lever cannot be shifted from the P position.
4. Depress the brake pedal and verify that the selector lever can be shifted from the P position. If there is any malfunction, inspect the selector lever component. (See SELECTOR LEVER COMPONENT INSPECTION.) Selector Lever Component Inspection
EMERGENCY OVERRIDE BUTTON INSPECTION
1. Turn the ignition switch to the LOCK position.
2. Verify that the selector lever is in the P position.
3. Without the brake pedal depressed, verify that the selector lever cannot be shifted from the P position.
4. Remove the panel cover using a screwdriver as shown in the figure.
5. Insert the screwdriver into the emergency override hole and push it down. Verify that the selector lever can be shifted from the P position. If there is any malfunction, replace the selector lever component.
SHIFT-LOCK SOLENOID INSPECTION
1. Disconnect the negative battery cable.
2. Remove the console.
3. Disconnect the selector lever component connector.
4. Measure the continuity between terminals E and F.
^ If there is any malfunction, replace the selector lever component.