Removal and Replacement

COMBINATION SWITCH REMOVAL/INSTALLATION

1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. Driver-side air bag module.
2. Steering wheel.
3. Meter hood.
4. Column cover.
5. Clock spring.

4. Remove in the order indicated in the table.






5. Disconnect the steering angle sensor connector.
6. Install in the reverse order of removal.

Combination Switch Removal Note




1. Pull the combination switch locks in the direction indicated in the figure and disengage the tab.
2. Pull the combination switch outward, then remove it.