Front Suspension

FRONT STABILIZER REMOVAL/INSTALLATION
1. Detach the steering shaft.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the wheel alignment and adjust it if necessary.





No. 1 Engine Mount Center Bolt Removal Note





1. Support the front crossmember using a jack.
2. Remove the No. 1 engine mount center bolt.

Front Stabilizer Component Removal Note





1. Detach the silencer hangers on the middle pipe from the front crossmember.
2. Lower the front crossmember slowly approx. 90 mm (3.5 in) and remove the front stabilizer component.

Stabilizer Bracket Installation Note





1. Verify the installation direction of the stabilizer bracket (the arrow should point to the front) by placing the stabilizer bar so that the identification mark faces the left side of the vehicle.
2. Install the stabilizer bushings and brackets so that they contact the stabilizer stoppers.

Front Stabilizer Component Installation Note





1. With the arrow on the stabilizer bracket facing the vehicle front, tighten the bolts.