Clutch Pedal Assembly: Service and Repair
CLUTCH PEDAL REMOVAL/INSTALLATION1. Remove the battery and battery tray.
2. Separate the steering shaft.
3. Separate the clutch pipe and reserve hose.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. After installation, inspect the clutch pedal.
Starter Interlock Switch Installation Note
1. Insert the new starter interlock switch into the pedal bracket hole in the direction indicated by arrow A.
2. Slide the starter interlock switch pressing it in the direction indicated by arrow B until it is locked.
3. Press the clutch pedal fully in the direction indicated by arrow C and adjust the starter interlock switch terminal.
Clutch Pedal Position Switch Installation Note
1. Insert the new clutch pedal position switch into hole of the pedal bracket until the switch stops.
2. Rotate the clutch pedal position switch 45° clockwise.
3. Verify that the clutch pedal position switch is locked securely.