Card Key ID Code Registration

CARD KEY ID CODE REGISTRATION [ADVANCED KEYLESS SYSTEM]

CAUTION
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed.
- M-MDS
- Personal computer
- Device that can send/receive radio waves
- Verify that the other transmitter is not being operated around the servicing area during card key programming.

NOTE
- Use the M-MDS and start programming if the condition corresponds to the following:
- One or No Programmed Card Keys
- Keyless control module is replaced
- If six card keys are already programmed, the programming mode does not activate. If programming is needed, use the M-MDS to erase the unnecessary card key programming.

With two programmed card keys

1. Bring the programmed card keys (2) and a unprogrammed card key into the vehicle.
2. Close all doors.
3. Insert the supplementary key into the ignition key cylinder.

NOTE
- Complete the procedures up to Step 7 within 30 5 after the supplementary key is inserted.

4. Turn the ignition switch to the ON position.
5. Press the UNLOCK button on card key 1.
6. Press the UNLOCK button on card key 2.
7. From the ignition switch in the ON position, switch the ignition switch in the order indicated below.
- ACC->ON->ACC->ON->ACC->ON

8. Open the driver-side front door, press the door switch twice, and then close the door.

NOTE
- After Step 3 is completed and the card key programming mode is activated, the door lock actuator operates to lock, and then operates to unlock.
- If the door lock actuator does not operate, repeat the procedure from Step 2.

9. Press the UNLOCK button on the unprogrammed card key twice.

NOTE
- After Step 8 is completed and the card key is programmed, the door lock actuator operates to lock, and then operates to unlock.

10. If programming more card keys, remove the supplementary key once, and then repeat the procedure from Step 2.

Using M-MDS

1. Fully lower the driver-side door glass.




2. Connect the M-MDS to the DLC-2.
3. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.

CAUTION
- Protect the cable and body contact area with a clean rag, otherwise they could be DLC-2 damaged.

4. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)
1. Select "Body".
2. Select "Security".

- When using the PDS (Pocket PC)
1. Select "Programming".

5. Then, select items from the screen menu in the following order.
1. Select "PATS Functions".
2. Select "Program Additional Card Key".

6. Security access begins and the M-MDS displays the "OUT-CODE".

NOTE
- When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times will change the "OUT-CODE".

7. Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed on the M-MDS screen.
8. Select "CARD KEY PROGRAMMING" from the M-MDS screen menu.

NOTE
- After Step 8 is completed and the card key programming is activated, the door lock actuator operates to lock, and then operates to unlock.

9. Press the unprogrammed card key UNLOCK button twice.

NOTE
- After Step 9 is completed and the card key is programmed, the door lock actuator operates to lock, and then operates to unlock.

10. If programming more card keys, remove the supplementary key once, and then repeat the procedure from Step 7 by following the instructions.