Reassembly

Reassembly
^ Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts. If removed, these parts should be replaced with new ones:
^ Oil seals
^ Gaskets
^ O-rings
^ Lockwashers
^ Cotter pins
^ Nylon nuts





Depending on location:
^ Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
^ Oil should be applied to the moving components of parts.
^ Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.