Engine Mounting

ENGINE MOUNTING
1. Install the SST (engine hanger) to the cylinder block holes as indicated in the figure, and tighten the SSTs (bolts).





2. Mount the engine on the SST (engine stand).
3. Drain the engine oil into a container.
4. Inspect the seal rubber of the oil pan drain plug and make sure there are no cracks or damage.
^ If necessary, replace the oil pan drain plug.
5. Clean the flange surface (seal rubber) of the drain plug, then install the plug.

Tightening torque
22-30 N-m (2.2-3.1 kgf-m, 16-22 ft-lbf)