Power and Ground Distribution: Service and Repair

ACCESSORY SOCKET REMOVAL/INSTALLATION

Front
1. Disconnect the negative battery cable.
2. Remove the panel No.1.
3. Remove the panel No.2.




4. Remove in the order indicated in the above table.
5. Install in the reverse order of removal.

Rear
1. Disconnect the negative battery cable.
2. Remove the console.




3. Remove in the order indicated in the above table.
4. Install in the reverse order of removal.

Socket removal note




1. Remove the socket by pushing on the protrusion with a tape-wrapped flathead screwdriver inserted through the socket hole, and pulling the socket toward you.

Cap removal note




1. Pull the cap forward while squeezing the tabs.