Rear Suspension

REAR SHOCK ABSORBER AND COIL SPRING REMOVAL/INSTALLATION

Caution:
^ Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before operations, remove the ABS wheel-speed sensor (axle side), and move the sensor away from the harnesses.

1. When working on the left side, remove the fuel tank protector.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.





Caliper Removal Note
1. Remove the caliper, and hang the cable out of the way.