Oil Seal (Extension Housing) Replacement

OIL SEAL (EXTENSION HOUSING) REPLACEMENT [SJ6A-EL]

1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Clean the transmission exterior thoroughly using a steam cleaner or cleaning solvent.
4. Drain the ATF.
5. Remove the following parts.
1) Tunnel member component
2) Middle pipe
3) Propeller shaft

Caution:
^ Do not to damage the extension dust deflector.
^ Do not to damage the extension housing.





6. Remove the extension housing shroud using a tape-wrapped flathead screwdriver.





7. Remove the oil seal (extension housing) using a tape-wrapped flathead screwdriver.





8. Using the SST and a hammer, install the new oil seal to the extension housing.
9. Coat the oil seal lip with grease.





10. Using the SST and a hammer, install the new extension housing shroud to the extension housing.
11. Install the following parts.
1) Propeller shaft
2) Middle pipe
3) Tunnel member component
12. Add ATF and, with the engine idling, inspect the ATF level and for leakage. (See AUTOMATIC TRANSMISSION FLUID (ATF) INSPECTION [SJ6A-EL].) Automatic Transmission Fluid (ATF) Inspection
13. Connect the negative battery cable.
14. Install the battery cover.