Drive/Propeller Shaft: Testing and Inspection

PROPELLER SHAFT INSPECTION





1. Use a dial gauge to measure the runout of the propeller shaft at each position. If it exceeds the maximum specification, replace the propeller shaft.
Maximum runout 0.4 mm (0.016 inch)





2. Inspect the play and rotation of the joint by turning the universal joint in the direction shown by the arrow.
Initial torque (Reference value) 0.29 - 0.98 Nm (3.0 - 10 kegs-cm, 2.7 - 8.6 inch lbs.)
^ If there is excessive play or initial torque, replace the propeller shaft.