[FN4A-El] Automatic Transmission/Transaxle

PID/DATA MONITOR INSPECTION [FN4A-EL]
1. Connect the M-MDS to the DLC-2.

PID/Data Monitor And Record Function Table (Part 1):

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
^ When using the IDS (laptop PC)
1. Select "DataLogger".
2. Select "Modules".
3. Select "PCM".
^ When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "PCM".
3. Select "DataLogger".
3. Select the applicable PID from the PID table.
4. Verify the PID data according to the detections on the screen.

Note:
^ Perform part inspection for the output device after PCM inspection.
^ The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM. Therefore, if a monitored value of an output device is out of specification, it is necessary to inspect the monitored value of the input device related to the output device control. Since an output device malfunction is not directly indicated as a malfunction of the monitored value for the output device, it is necessary to inspect the output device individually using methods such as the simulation function.

PID/DATA MONITOR AND RECORD function table

PID/Data Monitor And Record Function Table (Part2):