Blower Motor Resistor: Service and Repair
RESISTOR REMOVAL/INSTALLATION
1. Remove the battery and battery tray. Removal and Replacement Removal and Replacement
2. Remove the following parts:
a. Side wall Side Wall Removal/Installation
b. Front scuff plate (LH) Front Scuff Plate Removal/Installation
c. Front side trim (LH) Front Side Trim Removal/Installation
d. Hood release lever Service and Repair
e. Lower panel Lower Panel Removal/Installation
f. Column cover Service and Repair
g. Meter hood Meter Hood Removal/Installation
h. Instrument cluster Removal and Replacement
i. Steering shaft Service and Repair
j. Accelerator pedal Service and Repair Service and Repair
k. Brake pedal Service and Repair
3. Disconnect the blower motor cooling pipe connected to the blower motor.
4. Disconnect the resistor connector.
5. Remove the resistor.
6. Affix the gummed tape to the thread hole area as shown in the figure. (Do not wrap the packing tape around the backside of the resistor.)
7. Stick the screw into the thread hole.
8. Set the resistor to the A/C unit and temporarily tighten the hexagon head screw.
CAUTION:
- While setting the resistor, be careful not to damage the pattern surface. Otherwise it could cause a resistor operation malfunction.
9. Tighten the lower screw.
10. Tighten the hexagon head screw.
11. Connect the resistor connector.
12. Connect the blower motor cooling pipe.
13. Install the following parts:
a. Brake pedal Service and Repair
b. Accelerator pedal Service and Repair Service and Repair
c. Steering shaft Service and Repair
d. Instrument cluster Removal and Replacement
e. Meter hood Meter Hood Removal/Installation
f. Column cover Service and Repair
g. Lower panel Lower Panel Removal/Installation
h. Hood release lever Service and Repair
i. Front side trim (LH) Front Side Trim Removal/Installation
j. Front scuff plate (LH) Front Scuff Plate Removal/Installation
k. Side wall Side Wall Removal/Installation
14. Install the battery and battery tray. Removal and Replacement Removal and Replacement