Programming and Relearning

PCM CONFIGURATION [LF, L3]

1. Connect the M-MDS to DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

1 Select the "Module Programming".
- When using the PDS (Pocket PC)

1 Select "Programming".
2 Select "Module Programming".

3. Then, select the "Programmable Module Installation" and "PCM" from the screen menu.

4. Select "Programmable Parameters". [with DSC HU/CM]

5. Select "Tire Size / Axle Ratio". [with DSC HU/CM]

6. Select "Body Type - (PCM)", then select the applicable body type on the M-MDS screen. [with DSC HU/CM]

7. Retrieve DTCs using the M-MDS, then verify if DTCs are present.

- If a DTC is present, perform the applicable DTC inspection.