Radiator Support: Service and Repair

SHROUD PANEL REMOVAL/INSTALLATION

CAUTION:
- Because the shroud panel is installed to the front bumper reinforcement, support the shroud panel using a jack before removing the front bumper reinforcement so as not to apply excessive force to the shroud panel.

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Front bumper Removal and Replacement

b. Front combination lights Front Combination Light Removal/Installation

c. Front bumper reinforcement Service and Repair

d. Hood latch Service and Repair

4. Remove in the order indicated in the table.










5. Install in the reverse order of removal.

Upper Mount Rubber Bracket Removal Note

1. Remove the upper mount rubber bracket while pressing down the upper mount rubber bracket tab in the direction of the arrow.