Sliding Door Glass Removal/Installation

SLIDING DOOR GLASS REMOVAL/INSTALLATION

1. Fully open the sliding door glass.

2. Remove the battery cover. Removal and Replacement

3. Disconnect the negative battery cable.

4. Remove the side door garnish. Side Door Garnish Removal/Installation

5. Remove the rear side trim. Rear Side Trim Removal/Installation

6. Remove the sliding door trim. Service and Repair

7. Remove the bolt and screw.






8. Remove the rear door glass guide and glass run channel as a single unit.






9. Connect the negative battery cable.

10. Connect the power window sub switch connector.

11. Adjust the door glass position as shown in the figure.






12. Remove the hole cover.

13. Remove the bolt.






14. Lift the sliding door glass up and remove it by sliding it to the vehicle rear.

15. Install in the reverse order of removal.