Windshield Removal

WINDSHIELD REMOVAL

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Windshield wiper arm and blade Windshield Wiper Arm And Blade Removal/Installation

b. Cowl grille Cowl Grille Removal/Installation

c. Cowl panel Cowl Panel Removal/Installation

d. Rearview mirror Rearview Mirror Removal [Vehicles With The Auto Wiper System] Rearview Mirror Removal [Vehicles Without The Auto Wiper System] Rearview Mirror Installation

e. Rain sensor (vehicles with auto wiper system) Service and Repair

f. Sunvisor Service and Repair

g. Map light Service and Repair

h. A-pillar trim A-Pillar Trim Removal/Installation

i. Assist handle Service and Repair

4. Set the headliner out of the way.

5. Apply protective tape along the edge of the body.






NOTE:
- Overlap and adhere the protective tape to the corners to prevent damage.

6. Remove the windshield molding by pulling it outward.
NOTE:
- If the windshield molding is difficult to remove, warm the windshield molding using a hot air blower.
- The windshield molding is a replacement part.

Not Reusing Windshield

NOTE:
- For the areas of the sealant that are difficult to cut, use the piano wire and follow the procedure under "Reusing Windshield".

1. Cut out the sealant all around the glass using a sealant remover.






2. Remove the windshield.

Reusing Windshield

WARNING:
1 Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire.

NOTE:
- Before removing the windshield from the body, mark the position of the windshield by affixing tape to the windshield and body panel.

1. Avoiding the pin on the inside of the vehicle, insert the piano wire which has been cut to sufficient length.











2. Wind each end of the piano wire around a bar.
NOTE:
- Use a long sawing action to spread the work over the whole length of the piano wire to prevent it from breaking due to localized heating.

3. Secure one end of the piano wire, and while pulling the other end, cut the sealant around the windshield.






4. Pinch the pin from the inside of the vehicle and detach it.

5. Remove the windshield.

6. If the pin is damaged, remove the pin.

NOTE:
- Before removing the pin from the windshield glass, place an alignment mark on the windshield.