Antenna Feeder No.1 Inspection

ANTENNA FEEDER NO.1 INSPECTION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Upper panel Upper Panel Removal/Installation

b. Decoration panel Decoration Panel Removal/Installation

c. Shift knob (MTX) Service and Repair

d. Shift panel Shift Panel Removal/Installation

e. Center panel lower Center Panel Lower Removal/Installation

f. Center panel upper Center Panel Upper Removal/Installation

g. Climate control unit Climate Control Unit Removal/Installation [Full-Auto Air Conditioner] Climate Control Unit Removal/Installation [Manual Air Conditioner]

h. Audio unit (With audio system) Audio Unit Removal/Installation

i. Car-navigation unit (With car-navigation system) Service and Repair

j. A-pillar trim (RH) A-Pillar Trim Removal/Installation

3. Disconnect antenna feeder No.2.






4. Verify that the continuity between antenna feeder No.1 terminals is as indicated in the table.






- If not as indicated in the table, replace antenna feeder No.1.